Finding the system cause, beyond the fault code
When an industrial machine stops, the displayed error is often only the result. Power supply, field sensors, the safety chain, motors, encoders, networks, PLC programs, drive parameters or mechanical loads may trigger the same fault. Technical service assesses device and machine data together.
Service scope
- PLC and HMI: Diagnostics, I/O, communication, programs and backups, operator panels and modernization.
- Drives and servo systems: Fault codes, power stages, motors and encoders, parameters and field connections.
- Electronic boards: Physical and component-level fault analysis, with repair and testing where appropriate.
- Sensors and field equipment: Power supply, signals, connections, configuration and process conditions.
- Industrial communication: Connections, topology and device status in PROFINET, PROFIBUS, EtherCAT, Modbus and other networks.
Remote preliminary assessment before a site visit
Fault codes, LED states, nameplate details, control-panel photos and short videos can help define the service scope. Cases that require on-site measurements are not treated as a conclusive remote diagnosis.
Reducing repeated faults after repair
If a board or drive has failed because of an external load, wiring, excessive temperature, electromagnetic interference or mechanical stress, replacing it without addressing the root cause may not provide a lasting solution. Where needed, separate improvement or modernization recommendations can be prepared for the system conditions.
